[kawasakki]

Could anybody tell me if these are idiot proof to set up, or is this very simple to do? I was thinking about getting a innovative wide band I just don't know if I need someone mechanical to hook it up for me if it is a big hassel. :dunno: Thanks.

 

[Steve Wood]

I believe you can download the instructions on the innovate site.

Basically, weld a bung in the downpipe, run the wires, follow the calibration instructions.

Pay particular attention to the comments where the terminator plug goes.

Innovate also has a forum with lots of comments, and assistance, available.

 

[Doc1of7]

Could anybody tell me if these are idiot proof to set up, or is this very simple to do? I was thinking about getting a innovative wide band I just don't know if I need someone mechanical to hook it up for me if it is a big hassel.

The only trick is welding in another bung for the sensor.
All you need to do is follow the instructions, and you should be fine.
The only critical part is where, and how to mount the bung, but that's been well covered.