Turbo Buick Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
Pulled the trans out to replace torque converter. Decided to pull pan off trans while out of car. Having a little problem with the 1-2 shift being mushy. Could this be the problem? I noticed the tube is out of it's hole. What is it for? Thanks, Craig http://community.webshots.com/photo/98889237/98889593seMLtF

<small>[ November 07, 2003, 09:54 PM: Message edited by: Warp6 ]</small>
 

·
Registered
Joined
·
344 Posts
Lightly tap that tube back into the hole in valvebody make sure it fits tight.That will effect hydralic pressures.

<small>[ November 07, 2003, 10:27 PM: Message edited by: humberto ]</small>
 

·
aka: mOtOrHeAd MiKe
Joined
·
6,603 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #5 ·
I wonder if I could use a sharp punch and knock some dimples around the area where the pipe goes into the valvebody. That should tighten the hole up some. Any ideas?
 

·
Registered
Joined
·
344 Posts
I think that might work. thumb_up
 
1 - 9 of 9 Posts
Top