Turbo Buick Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6,887 Posts
If it is a stock turbo you might want to carve out the bypass hole where the thdp puck meets up to. Only reason for doing this to eliminate boost creep. HTH
 

·
Registered
Joined
·
6,887 Posts
Bigger turbo's usually have a bigger bypass hole. You can measure the hole and the size of the puck and check it. Also make sure to check that the puck seals good on the bypass hole, there have been occasions when they might be a bit off.

<small>[ April 23, 2003, 11:02 PM: Message edited by: forzfed ]</small>
 
1 - 4 of 4 Posts
Top