Turbo Buick Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
First Happy Holidays to every one.
Thanks for all the help.
How do you hookup an AutoMeter tach to
a turbo car. .

Thanks for your help.

------------------
87 GN Stocker 4,200 org.mi
87 W/b Interior Limited 153,000 org mi.
My Last Waltz,Going for 11's with this one.
Westchester,NY. Land of potholes
 

·
Resident Idiot
Joined
·
11,462 Posts
I have never installed a tach, but I am pretty sure you will need to hook the tach wire up to the green wire (also has a green plug) that is located behind the alternator. Ofcourse, don't forget to set the tach to 6cyl..

Hope that helps..

------------------
Email Address: mailto:[email protected][email protected]</A>


Current Combo: Stock Turbo, V4, MSD50's, TH DP, JayJackson 62mm TB, 16position MaxEffort Chip.
12.35 & 108.39 Street Trim.
 

·
Registered
Joined
·
1,693 Posts
I think it is white/wire green connector at alternator. The other two wires from the tach. One will be ground and the other needs to be a hot wire when lights are on. Best place for this is a grey wire under the radio portion of the dash.
And like O'87 said you cut one of the wires inside the tach to make it read 6 cyl.
 

·
Registered
Joined
·
50 Posts
Discussion Starter · #4 ·
Thanks for the help. I appreciate it.


Robert :0
 
1 - 4 of 4 Posts
Top