Turbo Buick Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
22,915 Posts
The easiest way to adapt would be to cut off the bottom section of the hotair "turbo to intake manifold adapter" and have it welded to the bottom of the compressor housing of the 49 (or any other TA series turbo). Measure it up correctly, have it welded, reclock the turbo and you're in business...other than some adapting to get the wg actuator to fit (or use a deltagate). It will work...if done properly.



 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top