Turbo Buick Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
228 Posts
Discussion Starter · #1 ·
i decided to do the DIY alky kit but had a question before i start. do i have to get a special chip burnt that recognizes the alky? can i run more boost say 20psi and have the alky kick in at say 13psi and still be ok on pump gas?
 

·
Village Idiot
Joined
·
4,813 Posts
You can use the chips you have but I would begin w/a street chip until you've proved everything out & are familiar w/it. 20 psi won't be a problem. You should be able to run 22-26 depending on which turbo you have. Setting the turn-on point can vary because of the hose length, pump output & etc but 2 psi below the point where the car usually begins to pick up knock is a good place to start.
 

·
Registered
Joined
·
152 Posts
Why don't they have an Alky Specific Forum on Turbobuicks.com? It would not have to be just alky it could be methanol, water, mix, any type of injection.

<small>[ August 23, 2003, 06:28 PM: Message edited by: kuku ]</small>
 

·
Village Idiot
Joined
·
4,813 Posts
If we get a bunch of threads like this one I'd definately be against it. ugh
 

·
Registered
Joined
·
6,966 Posts
I'd be up for a Ferd forum before another alky. forum. wink crazy
 
1 - 7 of 7 Posts
Top