[paul7885]

I believe this question has been asked before,but I don't remember the details of the fix.Problem is that my factory security light has started to stay on when you set the system.Also the light no longer flashes when the door is open with system off.Any info again would be appreciated.
Thanks

 

[ULYCYC]

You can try and pull the battery cable for a few minutes to reset the alarm. This may fix it. If not I'm sure you will get fast correct info here.
http://www.the12volt.com/installbay

 

[salvageV6]

Check the door jamb switches and the trunk lock switch for a short in the tan or light blue wires to ground. Or open circuit to IGN warning (tan wire), or open circuit to Arm and tamper input (light blue wire).