Turbo Buick Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,197 Posts
Discussion Starter · #1 ·
Ok. I know this question has probably popped up somewhere out there but...
What is the cc mode for? It seems to be the last mode on my SM 2.1
Also. What is L8, Intergrator, and Blocklearn mean in Laymans turns as I haven't a clue.
I bought an 84 T-type from my bro with an 87 GN engine. I was told by him he'd help me with things should problems arise. But I think you Buick Buffs may know a bit more than my bro.
Don't worry... I'll be back with more questions.
 

·
Registered
Joined
·
10,284 Posts
Hmm.
1.CC is crosscounts of the O2 sensor,I believe.
2.Integrator is a short term correction for the injector pulse width[fuel adjustment].
3.Blocklearn is the longterm correction factor for injector pulsewidth.
4.L8,I believe is your LV8[load filtered variable].It's based on throttle position,airflow,inlet temp,O2's,rpm,etc.
Picture a carburated car climbing a hill at 60 mph in high gear and at say,2200 rpm.
Now put that same car running under the same conditions on a flat strectch of highway.The engine load changes,right?That's LV8.

------------------
Give em' hell!
 
1 - 2 of 2 Posts
Top