Turbo Buick Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,938 Posts
Discussion Starter · #1 ·
I need the measurement from axel flange to axel flange.Maybe it is call something else?Ineed the measurement from where the wheel studs are pressed into(the outer side)to the other axel(same thing on the other side)I used two straight edges with a helper to measure it .I just want to make sure it is correct before I install the new 30 spline axels and new eaton possi and the c-clip elim.
Thanks all
P.S Sure was nice today...I got a sun burn!Ya ..in Canada! headbang dunno
 

·
Premium Member
Joined
·
43,735 Posts

·
aka: mOtOrHeAd MiKe
Joined
·
6,603 Posts
BigMike:

P.S Sure was nice today...I got a sun burn!Ya ..in Canada! headbang dunno
Go put on a shirt, ya muscle head! loser :D
silly
 

·
Registered
Joined
·
1,938 Posts
Discussion Starter · #4 ·
Motorhead Mike.
You sooo lucky!You can still buy your cloths at the Walt Disney store!
moon moon
BRAMPTON

Look ..two moons over Brampton^

<small>[ March 17, 2003, 11:07 PM: Message edited by: BigMike ]</small>
 
1 - 4 of 4 Posts
Top