Turbo Buick Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,200 Posts
Discussion Starter · #1 · (Edited)
Went to replace the pump and the pulley was so seized on, it bent. Where can I get one of these? All the parts houses say they don't carry them of course. Junk yard hopping the best bet? Are the puleys the same on 86-87 NA 3.8 regals??

Thanks guys!
 

·
Registered
Joined
·
2,347 Posts
junk yard or you can get pretty stock sized pulleys from rjc
 

·
Registered
Joined
·
2,200 Posts
Discussion Starter · #3 ·
I went and got an actual GM pulley puller and bent mine back. Suprisingly it is pretty true.

thanks...
 

·
Registered
Joined
·
994 Posts
My local Napa pulled it and installed my RJC for free. I had to retap it with a 3/8-16 to get all the rust out of it.

I have my old one if yours wobbles at high rpm.
 

·
Turbocharged BrunoStachel
Joined
·
4,813 Posts
That pulley fits 86-87 IC and TTA only. I dont think you'll have any luck in the yards on that one.
This place stocks them.
GBodyParts.com
3757 Baltimore Pike.
Littlestown, PA 17340
717.359.9692
http://gbodyparts.com/
 
1 - 5 of 5 Posts
Top