Turbo Buick Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I have recently installed an Alky Control system on my car. I don't know if I have done something wrong during the installation, but now there is no reading of boost or vacuum on the Scan Master. The green wire that provides the voltage signal for the Alky Control and the Scan Master still have about 1.62 volts with the key on, and it changes with throttle movement. Any thoughts?:dunno:
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #2 ·
Well, while checking the connection of the Scan Master to the ECM, I found the connection to be loose. I secured the connection, and now the Scan Master and the Power Logger are showing the boost level. I don't understand how it could have come loose and only not show the boost level. :confused:
 
1 - 2 of 2 Posts
Top