Turbo Buick Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
125 Posts
Discussion Starter · #1 ·
I'm going to be replacing the stock injectors with MSD 50# units. Any tips on making the job easier? About how long should it take on the average.
 

·
Registered
Joined
·
284 Posts
Remove throttle linkage from doghouse.
Take the air compressor and blow around each of the injectors to remove crud.
Spray some wd-40 on each injector a day ahead.
Remove coil pack and module.
Take the whole rail out with the injectors attached.
I wiggled the rail a little and pulled up at the same time, and the ones that didn't pop out I used a 3/4" wrench to gently pry them out.
They were stock and popped out easily.
Hope that helps a little.
 

·
Premium Member
Joined
·
43,735 Posts

·
Registered
Joined
·
293 Posts
I tried what Steve does, but on some cars the fuel line does not line up good with the regulator and it will not screw in, or worse it can cross thread. I had to remove the regulator anyways
 
1 - 4 of 4 Posts
Top