Turbo Buick Forums banner
1 - 2 of 2 Posts

·
Valve Monkey
Joined
·
574 Posts
Discussion Starter · #1 ·
Hi gang. I got the heads off yesterday and I definitely blew a head gasket. It went through to a coolant passage on #1 cylinder.
I need help coming up with the proper part #s for head and intake gaskets.
What was in it:
Head gaskets --------- FelPro 1000
Intake valley gasket - FelPro 96033
Is this what I should replace them with or is there something better? I've found more part #s on other sites than I can keep up with!
Any suggestions on which RTV sealants to use and where to apply them?
Thanks,

------------------
Richard Gautier
'87 GN, TE61, blue tops,IC and a half,Champion iron heads, Roller rockers,ported intake and plenum,70mm TB, Houston DP, no times yet!
 

·
Registered
Joined
·
99 Posts
Originally posted by SinistrV6:
Hi gang. I got the heads off yesterday and I definitely blew a head gasket. It went through to a coolant passage on #1 cylinder.
I need help coming up with the proper part #s for head and intake gaskets.
What was in it:
Head gaskets --------- FelPro 1000
Intake valley gasket - FelPro 96033
Is this what I should replace them with or is there something better? I've found more part #s on other sites than I can keep up with!
Any suggestions on which RTV sealants to use and where to apply them?
Thanks,

Go to www.gnttype.org/ for this information. look under RESUORCES,then PARTS #,pick the year of your car. If look with care,you should find the info you need.


------------------
 
1 - 2 of 2 Posts
Top