Turbo Buick Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
I got my MityVac in a few weeks ago. Played with it last week but could not get it to build more than 12-13psi. Anyone else have this problem.

------------------
Joe Tripodi 87 Limited-T 12.29 on street [email protected] 1.73 60' Stock motor, stock tranny, stock turbo, stock injectors, modified neck stock intercooler, 62mm TB, ATR 7th injector, Dual Deadhead Alcohol injection, 3" DP with dump, southside lift bars, 2800 stall convertor, Hot wired Walbro 307. MaxEffort 8 position custom thumbwheel with: fuel out, MAF lock, knock nozzle enable, and variable timing 18,20,22,24,26,28,34 degrees.
mailto:[email protected][email protected]</A>
Tel.716-422-9678 8:30am-4:30pm EST
Methanol/Alcohol Regulated & DeadHead Injection System Kits and Parts.
http://www.servtech.com/~racerx
 

·
Resident Idiot
Joined
·
11,462 Posts
It takes some force to make it build pressure. A little more than squeezing the lever and letting go.

You must push on the top of the lever to make pressure. You will see an area on the top of the lever that has "ridges" on it.

Best way to describe it, squeeze the handle with your right hand to increase pressure. When it stops, you must squeeze, then push on the top of the lever with your left thumb.

A back and forth motion with build max pressure.

Hope that helps.

------------------
Email Address: mailto:[email protected][email protected]</A>


Stock Turbo, Stock Heads, Stock CAM, V4, MSD50's, TH DP, JayJackson 62mm TB, 16position MaxEffort Chip. 3750# with Driver
12.35 & 108.39 Street Trim
11.92 @ 111.77 Race Ready
 
1 - 2 of 2 Posts
Top