Turbo Buick Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 · (Edited)
car has been sitting for ten years. on the pcm, the male terminals for the pcm harness have corrosion on them and so do the male terminals on the chip. i already ordered a reman pcm but not sure what chip to get or if i should clean the corrosion off the old chip. i assumed that the corrosion may have ruined the chip. its a Maximum Effort chip but i dont know anything about it or its settings on the thumbwheel. looking for a good street car set up. car is mildly modified. stock heads have been gasket matched and a valve job, turbonectics turbo size 62 i think is what the rebuilder said, terry houston down pipe, front mount intercooler, 3in stainless steel exhaust, rebuilt brf trans, external electric pump, slightly larger than stock cam not sure of lift numbers. any suggestions? thanx
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #2 ·
i get a high ilde at times and a rough start up...lobing for about a minute then it smoothens out but it may idle high once the lobing stops. most of the time, simply unplugging the chip and plugging it back in stops the high idle
 

·
GN Old Timer
Joined
·
90 Posts
Contact Eric at Turbo Tweak for a new chip.
 
1 - 3 of 3 Posts
Top