Turbo Buicks banner

1 - 4 of 4 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter #1
I have the ATR dual 3" exhaust and I looked under where the pipes go over the axles. I noticed that where the pipes start to go up(after the muffler) there was a mark there and on the axle. Any way to fix this?
 

·
Premium Member
Joined
·
43,735 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter #3
also I noticed the passenger side tail pipe hits the bottom of the rear quarter panel when going over bumps. Any way to fix that too?
 

·
Premium Member
Joined
·
43,735 Posts
LOL

have to play with the positioning of the hangers at the rear of the muffler and see if lifting the muffler at that point will drop the end of the tail pipe....

Don't feel bad, I have a 2 3/4" system from JCotton and I spent a long time double checking everything before I was satisfied and took the torch and tacked everything so it could not change. Six months later one of the tail pipes started rattling on the gas tank. It was an inch away and I cannot figure what shifted to allow it to rattle.

I just expect such things. frown



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3
 
1 - 4 of 4 Posts
Top