Turbo Buick Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
Hi guys,

here is my trouble. I get no power on pin A6 on the ECM, which in turn enables the SES which in turn enables eveything else. If I jumper it from ECM fuse to A6 it will start and run.

I get power up to the bulkhead (even through the brake light switch. but it is kind of difficult beyond that. Has anyone seen this before??

I MAY run a wire from the fusebox (without the fuse) with an inline fuse to A6 while also riging up the brake light switch, but that is fairly cheesy.

The fuse is NOT blowing so there is no short, is ther some other place (MAF, ESC) I can look for a bad connection or somehting>>

Thanks for your help in advance...

Bill
 

·
Premium Member
Joined
·
43,735 Posts
A6 comes from the ecm-ign fuse. It goes to a 15 terminal connector behind glove box and onto the ecm. Must have a bad connection somewhere in the loop.

Pink/black wire
 

·
Registered
Joined
·
43 Posts
Discussion Starter · #3 ·
Hi

Thanks Steve, I was not aware that there was a connector behind the glove box, I'll have to investigate. I too kthe rest of the dash apart why not the glove box??

Thanks again

Bill
 
1 - 3 of 3 Posts
Top