Turbo Buick Forums banner
1 - 3 of 3 Posts

·
MASTER GM TECH
Joined
·
676 Posts
Discussion Starter · #1 ·
so im adding the new sender for my vdo oil press guage (going in dual pod in front of shifter)
says i have to remove factor sender and use that hole
id like to be able to run my vdo guage but still maintain my factory dummylight
not always watching guages figure ill at least see dummy light if i lose press
dont wanna clutter int with external lights....
can i use some sort of brass t fitting or (i hope)
there is another hole i can use for the vdo guage??
thanks to all those who reply!!! cheers
 

·
Resident Idiot
Joined
·
11,462 Posts
You will need to use a T fitting. Your local hardware store should have everything you need. Hardest part is just getting down in that area below the turbo. Easiest to remove the radiator hose off the water pump for more room. Good luck!
 

·
MASTER GM TECH
Joined
·
676 Posts
Discussion Starter · #3 ·
thanks for quick reply actually sprayed penetrant on pet**** on rad to anticipate the removal of lower hose then logged on here
thanks
ps i will have enough room wont i??
 
1 - 3 of 3 Posts
Top