Turbo Buick Forums banner

Crank ID please

393 Views 4 Replies 4 Participants Last post by  KWIKR 1
What type of crank has rolled fillets on the mains, but not the rods?

Should this crank be used in a 600HP motor?
1 - 5 of 5 Posts
2
Originally posted by Orlando_87GN:
What type of crank has rolled fillets on the mains, but not the rods?

Should this crank be used in a 600HP motor?
That's your basic garden variety NA crank. I don't think I would try it in a 600 HP motor...haven't you had enough practice pulling motors this year?



------------------

Orange Park, FL
various cars, some running
http://photos.yahoo.com/frederik32212
See less See more
3
Well, I need another crank now and I found a nice 10/10 but it's evidently not the one for a high HP motor.

Off to the yards I go.. Thanks Kendall


------------------


Stock Block, Stock Cam, PTE-52, Champion Heads, V4, MSD50's, TH DP, JayJackson 62mm TB, 16position MaxEffort Chip. 3680# with Driver
12.0 @ 116.5mph w/20psi using 17.9* timing

mailto:[email protected][email protected]</A>
See less See more
Billy Anderson has routinely run cranks that were 30-30 according to some of his list posts....I would rather do that than to run the non-fillet cranks.



I have a buddy who has a turbo crank all ready to go . Turned 10/10 and balanced . Email me if interested and I'll hook you up....Tim.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top