Turbo Buick Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter · #1 ·
I have the PTE remote oiling system that comes with the braided turbo line. went to check the line today and noticed that is has been rubbing on some metal lines. Is there anything I can put around it to avoid the rubbing?

------------------
87 GN Hardtop~Stock motor, Mease stock intercooler w/Duttweiler big neck,stock intake, stock tb and plenum, TE51 w/.63 housing, stock D5, MSD 50's, THDP, ATR 3" dual exhaust, big mouth cold air inducition, SMC alchy injection and egt gauge, MM boost command, PTE remote oiling system, Walboro 340 hotwired, 10 mm Magnecor wires, AC R43 plugs @.035 Adjustable regulator, ATR 3" maf pipe, B&M tranny cooler, Deep aluminum tranny pan, Dynotech shift kit, scanmaster 2.1, 21* Testa alchy chip, dual airbags, vdo gauges, autometer boost gauge, front braces and rear seat brace, Bilstein shocks, more mods to come
 

·
Registered
Joined
·
6,966 Posts
Plastic loom, tape, rubber hose...

Depends on what exactly you want to do.
 

·
Registered
Joined
·
1,293 Posts
You need to route it so it does'nt rub anything.
 

·
Registered
Joined
·
81 Posts
how do you keep it from leaking? I have to retighten mine every couple weeks, and I've tried various configurations/routings. (the filter adapter, not the braided turbo feed)

[This message has been edited by slojim (edited May 01, 2002).]
 
1 - 4 of 4 Posts
Top