[Grannynational]

So I was porting my heads and I hit a cooling passege about half way down the port. I dont think they can be fixed can they?
Anybody know where I can get one head?

Joe

 

[Boosted Bob]

Not too bad, you should be able to get another head for 50 - 75 bucks if yours was stock.

All 3.8's for 86 and 87 had the same 8445 heads. Just make sure the one you get hasnt been milled a hole lot more than the one you are keeping

I would just buy two since they are so cheap, and you will have another to practice on

 

[Steve Wood]

were you using the templates?



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3

 

[itsMILLERtime]

Where did you poke through? I'm porting my heads right now and I want to be careful.

Mike

 

[Grannynational]

I was just using the pictures from Gnttype.org. So let me get this right, all 3.8's even the N/A cars have 8445 heads?

I'm thinking of JB welding it, sombody told me that stuff works real well.

Joe

 

[Grannynational]

The hole is halfway in the intake port in the middle cylinder.

Joe

 

[Steve Wood]

sounds like you were hogging them out...gnttype.org has a section on heads...they are very common.



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3

 

[Don Palumbo]

Forget the J-B weld...

 

[Grannynational]

I think I found one around here locally, yes I admitt, I was hogging them out pretty good, but I was seeing a lot of light shining through that port, they were looking nice, until I put a hole in it

Joe

 

[Steve Wood]

try to remember that size is not the major concern, not when it comes to porting anyway.

Only minor metal removal is required in the ports..



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3