[Tire Burner]

ok guys i just installed the alky control kit:headbang: and i will be taking it out for its madien voyage tomorrow:headbang: is there any thing i have to change in my gen 2 translator now that there is a different 3 bar map :dunno: ( i have a anolog dash since i think i read some were it makes a difference) thanks guys

 

[turbo nasty]

Post up your GEN2 settings and we ca give you a hand. I would send the TT chip back to Eric for a alky reburn

 

[Tire Burner]

ok the system settings are as follows
main scale + 20
v out 1 set 2.560
v out 2 4.00
after start 0
low load point 32.5
mid load 100.1
hi load 143
f outmax 0
maf lim tps
tps enrich .1
tps decay.6
off idle fuel 0

user high load is + 10% from 3400 rpm to 7800