Turbo Buick Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Newb to this site.. Adjusted cam sensor today and now the car won't start, wet plugs, no spark, and it turns over slowly and unevenly with the cam sensor plugged in, but turns over normally with it unplugged. I can hear the injectors pulse when I crank it, but no spark at all, seems strange, I've already swapped coil packs, no luck. Any suggestions appreciated,

Thank you
 

·
Older than dirt
Joined
·
2,717 Posts
Start over with resetting the cam sensor.
Keep cranking the engine with the fuel flooding it, and you can jack a rod out the side of the block.
It turns over "normally" w/ it unplugged, as the injs are not firing.
Why were you "adjusting" it, to begin with?
 

·
Registered
Joined
·
84 Posts
I don't think the cam sensor has anything to do with spark, its a crank sensor thing...I would look towards ignition module, check ignition module fuse also, towards top left of fuse box.....When you are getting spark, if the cam sensor isn't dead on for fuel injection timing it isn't gonna run. Use the cam sensor tool that lights up.
 
1 - 3 of 3 Posts
Top