87 GN Parts 4 Sale/trade - Rear Axle, Fenders, 1/4s, ect...

[2 qk 4 u]

For Sale Items are all located in Troy, OHIO 45373
All oversized items to be picked up. Small Items are + shipping via USPS/UPS
I accept Paypal, Money Orders, Cashier Checks.

All parts coming from this 1987 Buick Grand National with 110k Miles (Bad Frame) Unless otherwise specified. I can take digital pics of all items if required, I posted a few exterior pics below.

8.5 Posi Rear Complete Drum to Drum - $750
Complete Engine Wiring Harness - $400
Drivers Side Front Fender (no rust/no dings/no dents, comes with emblems)- $150
Passenger Side Front Fender (no rust/no dings/no dents) From 84 n/a Regal - $100
Header Panel from 85 N/A Regal (good shape) - $100
Core Support (steel) - $Make offer
Grille From 85 N/A Regal (good shape, painted to match GN) - $40
Stock Fuel Pressure Regulator - $10
Transmission Crossmember (no rubber) - $35
Black Head Light Bezels (nice shape) - $50
Front Air Dam Left and Right Set(have minor defects) - $40
Driver Side Door (minor rust, dings, small crease, no lock cylinder) Power Window/Lock good- $175
Driver Side Mirror (nice shape) - $25
Rear View Mirror (nice shape) - $15
Rear Bumper Fillers (NO Cracks, good shape but faded) - $95*sale pending*
Trunk Hinges (nice shape) - $Make offer
Hood Hinges with good shocks - $Make offer
Cowl Rubber Seal (soft/no tears) - $Make Offer
T-Top Glass Left & Right (locking w/key incl) some scratches $150 for set
T-Top Bags (nice shape) - $40
T-Top Interior Center Piece (grey) - $30
Windshield blackout trim 3 pieces $45 *sale pending*
Rear window Blackout trim 3 pieces $35 *sale pending*
Power Master Unit, Complete Unit (off of 41K mile GN) $250
Throttle cable (from pedal to TB) $35
ECM $75
AC lines $45
Power Steering Gear Box - $40
Blackout wheel well trim $40 each please specify when ordering *RR sold* *sale pending on the rest*
Bumper(GN Rear black bumper, not perfect but close) $70*sale pending*
Bumper(GN Front black bumper, not perfect but close) $70*sale pending*
Rear Tail Lights (No Blackout trim) - $65 *sale pending*
Quarter windows with blackout trim $100 for both sides
Windsheild Blackout Lower Piece - $Make Offer
Windshield wiper assembly $15
Windsheild Wiper Motor/Washer Assembly (works good) $45
Fuel Injectors/Stock - $5 each *sale pending on 6, have 6 more!*
Window Power Motors/NEW - $Make Offer
Gas Tank EFI - (no shipping available) $35
Heater box(Complete heater box, For AC car) $80
Upper Control Arms (Front) L & R available - $Make Offer
Lower Control Arms (Front) L & R available - $Make Offer
Upper Control Arms (Rear) L & R available - $Make Offer
Lower Control Arms (Rear) L & R available - $Make Offer
Sway Bar (Front) - $40
Sway Bar (Rear) - $50
Exhaust/xmember Hanger - $Make offer

PARTS THAT I NEED AND WILLING TO TRADE PARTS ABOVE

Grey Hardtop Interior Pieces, the plastic and metal ones.
Upper door panels (cardboard must be dry and good shape) Need for leather covering.
3" downpipe with internal WG (TH or Mease)
3" Single Shot Exhaust (no muffler needed)
Set of wheels (prefer stock GN wheels or weld, centerline) Need something.
Coil Pack/Ignition Module (must be in new/good shape)
Chrome Up Pipe
Silicone Turbo Hoses (color doesn't matter)
3,000 to 3,500 200R4 convertor
Any GN Racing Parts you may have I'm intrested.

Thanks!

[jdodman]

I will take all 4 wheel well trim as well as the front and back window trim.

PM me your address with total cost / shipping.

Joe

[2 qk 4 u]

Originally Posted by jdodman

I will take all 4 wheel well trim as well as the front and back window trim.

PM me your address with total cost / shipping.

Joe

I have 3 wheel well trims. Sold the passenger rear.

PM sent

[turbo_scooter]

would you be willing to cut the left rear 1/4 pannel out, i just need a patch, i could send you a pic of what i need, cant seem to find new patches anywhere.

[2 qk 4 u]

Originally Posted by turbo_scooter

would you be willing to cut the left rear 1/4 pannel out, i just need a patch, i could send you a pic of what i need, cant seem to find new patches anywhere.

Yes I can cut it out.
Where are you located?
I cannot ship it so you would have to pick it up. I'm in Troy, OH 45373
Send me a pic of what you need.


Thanks

[Zerstoren77]

im interested in your front and rear sway bars. will u ship them? are they stock?

[2 qk 4 u]

Originally Posted by Zerstoren77

im interested in your front and rear sway bars. will u ship them? are they stock?

Yes and Yes....PM sent

Thanks!

[2 qk 4 u]

Both Sway Bars.....***Sale Pending***

[mcnastyz]

can you please tell me if these parts are still available>? and if so please reply to me at ff2359@aol.com i am north of chicago and interested thanks frank II

[2 qk 4 u]

Sorry, all parts are gone.