IGN source

blackbrick · 12-25-2006, 02:22 PM

When installing my razor alky kit i come to the part where it says to place one of the wires in a switched ignition source in the fuse block. I noticed that the 3 unused ign spots in the fuse block are dead.(yes the key is in the on position). Does anyone have any advise to fix this or can i use another spot. Every thing else in the fuse block works fine.

salvageV6 · 12-26-2006, 12:57 AM

IGN 3 is off the A/C fuse in the fuse box.

IGN 1 is off the ST BLT/ACCY fuse in the fuse box.

Remember you have to have the key ON to test for voltage.

IGN 1 has 3 slots.

I believe IGN 3 has one slot.

12-25-2006, 02:22 PM	#1 (permalink)
blackbrick Registered User Join Date: Feb 2006 Location: Dover, DE Posts: 126	IGN source When installing my razor alky kit i come to the part where it says to place one of the wires in a switched ignition source in the fuse block. I noticed that the 3 unused ign spots in the fuse block are dead.(yes the key is in the on position). Does anyone have any advise to fix this or can i use another spot. Every thing else in the fuse block works fine.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-26-2006, 12:57 AM	#2 (permalink)
salvageV6 Registered User Join Date: Sep 2000 Location: Connecticut, USA Posts: 6,431	IGN 3 is off the A/C fuse in the fuse box. IGN 1 is off the ST BLT/ACCY fuse in the fuse box. Remember you have to have the key ON to test for voltage. IGN 1 has 3 slots. I believe IGN 3 has one slot.