| | | | | | |
| | | | | ||
| | | | | ||
| | | | | ||
| | | | | ||
| | | | |||
 |
11-05-2004, 07:54 AM
| #1 (permalink) |
| Registered User  Join Date: Oct 2002 Location: Wichita KS
Posts: 1,711
| Small praise to alcohol injection.... I've always had a problem with my car (or so I thought) with the boost not coming up over 17lbs. Early in the game I installed a DIY ALKY injection kit just for a safe guard. Set to come on around 8 lbs. Recently found out the new in the box boost guage I had bought was defective, after installing a new gauge and setting the boost knob in the previous position it had been I was hitting 28lbs! This is with 5 gal 100 octane and a full tank of 93. I'm sure I was getting some serious knock(running DFI W/o knock sensor at the moment...doh!) and my motor was crying but It is still here to tell the tale and I'm pretty sure without alcohol injection it wouldn't be! I solute you alky injection! 
__________________ 86 Rx-7 GXL Hybrid 86 Grand National motor and trans. TRW pistons, Webber ported IRONS, Extender chip,Translator plus,Te-45a, Vig.Torque Conv.(3500), Trans Cooler, 55lb inj's, 10mm Race Wires, Adj. FP Regulator,RJC PP ,FMIC 18x32 spearco bar&plate, Custom 3 inch mandrel DP, postons X-over pipe. deltagate WG, 3.40 rear, WB 02 255 60 MT Progressive alky, 1 m15 nozzle. Best E.T. 10.65 Best MPH 131.4 Still tuning.  |
|  |
 |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
