| coolingmist,
Im not wanting a refund/replacement at this point. But I am TELLING YOU that for future reference the rattling of loose screws was BEFORE I had done any investigating to the controller. The screws were loose before I attempted to take it apart. PLus, there are 4 screws that hold the backing plate onto the circuitboard, 4 that hold the plate onto the housing, and 4 more on the backside of the board that hold on splicer nuts...big deal. Any of those screws can come loose due to vibrations. Furthermore, that stupid little harness connector that you're talking about is absolutely pointless. All you have is a system ground, ignition, and ground/hot that goes to the pump. The two little map wires were cut b/c of the fact that I didnt want a wad of wires hanging off the controller. I have built many complete wiring harness for vehicles an am an electrician by trade, so it's not that confusing. Just think about this the next time someone in my situation comes up to you with a broken product that you put together...."The customer is always right."
later
Jordan |